A guitar tube amp effects loop is an input and output section between the preamp stage and power amp section in your amplifier. It normally appears on your amp as the send and return. What this means is that you can use the preamp – which is where your amp gets its tone and voice from – in your actual signal chain with your pedals. This is called preamp distortion.
This is particularly important for players that use their amp for distortion sounds but still want clear delay and reverb sounds from their pedals.
Often you’ll hear the term ‘the perfect pedal platform amp’. What this means is that the amp has loads of clean headroom so that the pedals can give your guitar sound the voice. The amp itself won’t compress or saturate until much higher volumes which means it’s a platform for you to use all of your wonderful, juicy guitar pedals!
Normally, with a ‘pedal platform’ amp like a Fender Hot Rod Deluxe, you’ll simply have all of your guitar pedals in a certain order going into the front of the amp. You’ll use pedals for distortion and because of how you set up your board, you’ll probably have Modulation > Delay > Reverb a bit later in the signal chain.
Some amps don’t even have an effects loop and this is generally because they are pedal platform amps. These amps are generally single channel and won’t have distortion on-board.
But what do you do if you use your amp for distortion and not pedals?
This is where an effects loop comes in because it means you can still use your drive and boost and compression pedals into the front like you normally would, but you can put your Modulation > Delay > Reverb into the effects loop which puts them after the preamp. And remember the preamp is the part of the amp that is giving you that saturated distortion sound anyway?
So essentially, an effects loop gives you the ability to use your amp distortion in the right place in your signal chain.
It’s worth noting that whilst these are all suggestions, there is absolutely no right or wrong way to wire your pedal board and the best guitar pedal order for your pedalboard is merely a guideline.
Guitar > Tuner > Boost > Overdrive >Distortion > Fuzz > Modulation (like Chorus/Flanger/Phaser etc.) > Delay > Reverb > Clean Channel on guitar amp.
If you did the same thing with an effects loop because you want to use the amp for distortion, it would look like this.
In front of the amp
Guitar > Tuner > Boost > Overdrive > Distortion > Fuzz > Front of amp.
Effects loop send > Modulation (like Chorus/Flanger/Phaser etc.) > Delay > Reverb > Effects loop return.
I’d suggest some experimentation, especially with the order of your modulation pedals in the effects loop as there aren’t really any hard and fast rules.
I don’t suggest using any boost, overdrive or distortion pedals in the effects loop as these will boost the gain and the signal and could cause damage to your guitar amp by overloading the power amp. Tread with caution as you could end up breaking your amp completely.
Generally speaking, delay comes first and then reverb. That way the delay repeats will also be covered in that lovely reverb but still be clear enough to be heard. The other way around will mean that the delay repeats your reverberated sound. This could create a cool effect but certainly not the most versatile.
You should use an effects loop if:
You shouldn’t use an effects loop if:
Whenever Strymon releases something new, everyone at Andertons instantly stops whatever they're doing and immediately starts patching cables and flicking…
Looking for a silent practice tool with a small footprint? Then you might want to consider using one of the…
Ed Sheeran is a multi-platinum award-winning artist who’s famously known for being a one-man band on stage. And many people…
The desktop guitar amp market is getting more popular, but with many companies now creating their own ranges to enter this…
The Fender Vintera II electric guitars are now released! You may be wondering what is so special about these guitars, and how…
A new year, a new beginning, a new piano? But which one should you pick and how can you tell?…